Welcome to Tribbeck.com

My Wanhao 3D printer

I bought a Wanhao Duplicator 4X printer a few months back, and it's now about time I did some pictures.

I've built a cupboard above the printer to hold the spools. In the cupboard there are two rechargeable dehumidifiers - and currently the humidity is 32% (which is about the lowest I've seen from this):

Click to download Click to download

To the side of the cupboard there is a slot where I can also insert and remove large PCBs (since they also need to be kept away from humidity):

Click to download

And underneath the cupboard there's three holes to allow the filament to leave. There are actually more, but the end ones aren't really that useful (I feel they put too much strain on the printer):

Click to download

In the cupboard there is also a temperature and humidity sensor:

Click to download

And the dehumdifiers change colour to show when they need recharging (which is a simple matter of removing them from the cupboard and then plugging into the mains for a few hours). On the left, it's okay; on the right it needs recharging:

Click to download Click to download

Updated: 2014-11-20 21:19:24 | Comments: 0 | Show comments | Add comment
© Copyright 1997-2017
Tribbeck.com / Jason Tribbeck
All trademarks are the property of their respective owners.